I was casing a card on page 111 of the new
StampinUp catalog and wanted to share
how I used the Banners Framelits Dies to make the card base.
Sorry for the blurry photo. I didn't see that the photo was
like that till I loaded it to the blog.
Cut the cardstock 3 1/4 x 11. Then score
at 5 1/2. Fold the cardstock in half at the score line.
Using the largest framelit from the Banners set place the
cutting mat on the magnetic board, next place the folded cardstock.
Place the framelit cutting side down over the cardstock with the flat part
of the banner just a little bit above the score line. Add the second cutting mat over
the framelit then run through the Big Shot. By doing this the framelit will
not cut through the top, and you will have a little banner card to decorate.
I used Banner Banner stamp set and the matching banner punch.
Stamping trails
Karen
No comments:
Post a Comment